How To Make Perfect Hard-Boiled Eggs - Once Upon a Chef (2024)

FAQs

How do you boil eggs once upon a chef? ›

According to our friends at Delish, adding a teaspoon of baking soda to your boiling pot of water will help the shell peel off seamlessly. Why? The alkaline in the baking soda will help your egg whites loosen up from the shell, making it easier to peel.

As soon as the water begins to boil, turn off the heat and cover the pot. Leave the eggs in the hot water for anywhere from 10-12 minutes, depending on how you like your eggs. The 10-minute eggs will have vibrant, creamy yolks, while the 12-minute yolks will be paler and opaque, with a chalkier texture.

Bring the water up to a boil. As soon as the water boils, turn the pot off. Leave the lid on the pot, and let the eggs sit for 10 minutes. Run them under cold water until the eggs have cooled back down and they're ready to peel and enjoy.

Bring the water to a boil, then cover the pot and remove it from the heat and wait 12 minutes. If you're skeptical, feel free to take an egg out of the pot at 12 minutes, run cold water over it, and open it up to see if it's done to your liking.

Lower the heat slightly – so the eggs don't crack due to being bashed around but water is still at a gentle boil. Start the timer – 6 minutes for runny yolks, 8 minutes for soft boiled, 10 minutes for classic hard boiled, 15 minutes for unpleasant rubbery whites and powdery dry yolks.

The vinegar in the water makes the eggs easier to peel. Here's why: The vinegar's acid not only dissolves some of the calcium carbonate in the shell, it also helps the whites set faster. Running the hard-boiled eggs under cold running water as you're peeling, meanwhile, helps the shell separate from the membrane.

Carefully place the eggs in a large saucepan; add cold water to cover by one inch, and bring to a rolling boil. Cover pan; remove from heat. Let stand 12 minutes, then drain and rinse under cool water. To store, keep eggs unpeeled in the refrigerator, up to 4 days.

How does Ina Garten make hard-boiled eggs? ›

Place the eggs in a saucepan and add enough cold water to cover. Bring the water to a boil and immediately turn off the heat. Let the eggs sit in the pan for 15 minutes. Remove the eggs to a bowl and allow to rest for at least 2 minutes.

To perform the float test, gently set your egg into a bowl or bucket of water. If the egg sinks, it is fresh. If it tilts upwards or even floats, it is old. This is because as an egg ages, the small air pocket inside it grows larger as water is released and replaced by air.

The main difference when comparing hard-boiled vs. soft-boiled eggs is how cooked the egg whites and yolks are. Hard-boiled eggs are firmer because the egg is fully cooked so that there's no runniness. Soft-boiled eggs are only partially-cooked, so they have a runny yolk and a less-firm exterior.